Replacing The Light Bulbs; Main Fuse; Checking The Tyre Pressure; Checking The Engine's Cooling Air Intake - Husqvarna Rider 15T Operator's Manual

Replacing the light bulbs

For information about the bulb type, see Technical Data.
1 Loosen the lock nut and remove the Allen bolt. Remove
the steering wheel.
2 Unscrew the two screws holding the cover on the power
servo housing. One screw on each side.
3 Press in the parking lock button and lift the cover over the
steering column.
4 Carefully remove the lamp insert from its two brackets.
5 Disconnect the cables from the bulbs.
6 Lift out the bulbs from the insert.
7 Insert the new bulbs. Make sure you use your thumb to
support the front.
8 Refit the cables, lamp insert and the cover on the power
servo housing.
24 –
English
Maintenance
9 Replace the steering wheel.

Main fuse

The main fuse is placed in a detachable holder under the
battery case's cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.

Checking the tyre pressure

The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.
Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.