Fitting The Cutting Head - Husqvarna Rider 15T Operator's Manual

Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
WARNING! The cooling air intake rotates
!
when the engine is running. Mind your
fingers.

Fitting the cutting head

WARNING! Wear protective glasses when
!
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
1 Place the Rider on a flat surface and apply the parking
brake.
2 Check that the lever for setting the cutting height is in the
lowest position and that the lifting lever for the cutting unit
is in mowing position.
3 Push the equipment frame down and place the catch
against the frame.
Maintenance
4 Engage the belt in the belt holder.
5 Push the deck in and put the front guide plugs in the
grooves on the equipment frame, one on each side.
!
6 Lift up the cutting unit
7 Push the unit in so that the interior plugs touch the bottom
of the equipment frame's grooves.
8 Fit the drive belt around the drive wheels of the cutting
unit. Make sure the belt is placed on the correct side of the
belt tensioner wheel.
WARNING! Observe caution to avoid
trapping your hand.
– 25
English