Adjusting The Parking Brake Rider 15T; Adjusting The Parking Brake; Checking And Adjusting Of Throttle Wire - Husqvarna Rider 15T Operator's Manual

2 Check the tension of the steering wires by squeezing
them together by the arrows as illustrated. It should be
possible to push them together so that the distance
between them is half as much, without using unnecessary
force.
3 If necessary, the wires can be adjusted by tightening the
adjuster nuts on each side of the steering collar. Do not
over tighten the cables; they should only be drawn in
towards the steering collar.
Hold the cable, for example using an adjustable wrench,
so that it does not twist.
If the adjustment is only made on one side, the middle
position of the steering will be affected.
Check the wire tension on completion of the adjustment
as per item 2.
Adjusting the parking brake Rider
15T
The parking brake is adjusted as follows:
1 Loosen the locking nuts (1).
2 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
3 Tighten the locking nuts (1) after adjustment.
4 The parking brake should be checked again after the
adjustment has been made.
WARNING! A poorly adjusted parking brake
!
can result in reduced braking ability.
Adjusting the parking brake Rider
15T AWD and Rider 15Ts AWD
Check that the parking brake is adjusted correctly by placing
the machine on a slope with the front and rear axles
disengaged.
20 –
English
Maintenance
Apply and lock the parking brake. When the machine does not
stand still, the parking brake should be adjusted according to
the following.
1 Remove the left-hand wing cover.
2 Loosen the locking nuts (1).
3 Tension the cable using the adjuster screw (2) until the
play in the cable is taken up.
4 Tighten the locking nuts (1).
5 The brake should be checked again after adjustment
6 Assemble the left-hand wing cover.
Checking and adjusting of throttle
wire
Check that the engine responds to the throttle control and that
the correct engine speed is achieved at full throttle.
If doubts arise, contact your service representative.
If adjustment is necessary, adjust the lower wire as follows:
1 Loosen the clamping screw for the cable's outer casing
and move the throttle to the full throttle position.
2 Check that the throttle wire is attached to the correct hole
in the lower lever, see diagram.
3 Pull the throttle wire casing to the far left and tighten the
clamping screw.