1
Introduction
LED
Condition
Power
On Green
On Amber
Off
Diag
Flashing Green
On Green
On Amber
Alternating
Amber & Green
RPS
On Green
On Amber
Off
Optional Redundant Power Supply
The switch supports an optional Redundant Power Supply (RPS) that can supply
power to the switch if the internal power supply should fail.
Power Supply Receptacles
There are two power receptacles on the rear panel of the switch. The standard
power receptacle is for the AC power cord. The receptacle labeled "RPS" is for the
optional Redundant Power Supply (RPS).
Redundant Power Socket
1-4
Figure 1-3 System LEDs
Table 1-2 System Status LEDs
Status
Internal power is operating normally.
Internal Power supply fault.
Power off or failure.
System self-diagnostic test in progress.
System self-diagnostic test successfully completed.
System self-diagnostic test has detected a fault.
Fan failure or system overheated.
Redundant power supply is receiving power.
Fault in redundant power supply (including thermal or fan).
There is no redundant power supply currently attached.
RPS
DC
12V 13A
Figure 1-4 Power Supply Receptacles
System Indicators
Power Socket
100-240V~
50-60 Hz 0.6A