Table of Contents
Advertisement
Transceiver Unit
4
General mounting considerations
Determine the mounting location for the transceiver unit considering
operator convenience, proximity to the power source and the ground
location. Keep these and the following points in mind when selecting
a mounting location.
• Locate the unit in a place free of water spray and water splash.
• Keep the unit out of direct sunlight because of heat that can build
up inside the unit.
• Leave a little slack in cables to allow a service technician to move
the radio from its usual location with the cables connected. This
lets him make tuning and other adjustments on a "live" set.
• Do not install the unit where flammable gases are stored.
• Select a well ventilated area.
• Ensure the mounting location is strong enough to support the weight
of the unit (6 kg) under the condition of continued vibration nor-
mally encountered aboard the vessel. If necessary, reinforce the
mounting area with a doubling plate or lining block.
• Leave sufficient space at the sides and rear of the unit for mainte-
nance and service purposes and to provide for circulation of cool-
ing air. The minimum service clearance appears in Figure 2.
• For flush mounting, select a location where the LCD can be eas-
ily viewed.
Note:
Take great care not to press the DISTRESS switch during the
installation. If you accidentally press the switch, immediately turn
off the equipment and contact appropriate authority by telephone.
3. Mounting
Hide quick links:
Advertisement
Table of Contents
