Table of Contents
Advertisement
1.
Loosen the Table Adjustment Locking Handle (26) by turning it counterclockwise as
shown above.
2.
Tilt the Table (29) to the desired angle: Use a protractor to ensure accuracy. There
should be no more than 1/16" between the Table and the Sanding Belt (5).
3.
Tighten the Table Adjustment Handle.
1.
Using a protractor, verify that the Table is 90° to the belt. If it is not, continue with the
following steps.
2.
If the Table is tilted toward the front of the machine, tighten the Set Screw (30).
3.
If the Table is tilted toward the back of the machine, loosen the Set Screw.
Tension Handle (37)
(Also use for belt
tracking adjustments)
Back Pulley (14)
1.
Remove the Cover Knob (16), then remove the Side Cover (#10) as shown above.
2.
Turn the Tension Handle (37) counterclockwise to loosen the Sanding Belt (5).
SKU 02485
Adjusting table Angle
leveling the table
removing and installing sanding belt
Sanding Belt
for technical questions, please call 1-800-444-3353.
Tracking Knob (16)
Cover Knob (16)
Side Cover (10)
Page 11
Hide quick links:
Advertisement
Table of Contents
