Disarming The System - Crime Guard 328i4 Operation Manual

alarm cycles. After the third alarm cycle the system will automatically rearm
and bypass the open zone until that zone returns to a non-violated state.
• Once the system resets after it has been activated, upon disarming the
audible and visual confirmation will change to indicate the activation.
This is the "Activation Alert", which is explained on the next page.

DISARMING THE SYSTEM

There are two methods of Disarming the security system:
1- The first is to press and release the transmitter's Upper Right "Unlock"
Button to disarm the system. This is the normal "daily use" method.
2- The second method is for emergencies, should the transmitter become
lost or inoperable. This is the "Emergency Override", which uses the
ignition key and Valet Switch.
To Disarm the System:
Press & Release the Upper Right
THE SIREN WILL CHIRP
ONCE TO CONFIRM
DISARMING
Upon Disarming:
The siren will chirp once (or three times if an alarm activation occurred)
unless the silent disarming procedure is followed.
The parking lights will flash once and then illuminate for 30 seconds, or
until the ignition key is turned on.
The doors will unlock.
The Status Light will show one of these conditions:
-Off = System disarmed (Automatic Rearming feature not selected).
-Flashing rapidly = The Automatic Rearming feature is in progress.
-Flash /Pause = Indicates violated zone if system has been activated.
If an optional starter interrupt is installed, it will disengage.
•
"Unlock" Button (
THE PARKING LIGHTS
WILL ILLUMINATE
TO CONFIRM
DISARMING
THE DOORS WILL UNLOCK;
Either All or Drivers Only
Page 8
Feature #10 Not used on this model
Feature #11 Open Door Bypass Of Ignition Locking
This feature cancels the automatic locking or unlocking of the vehicle's doors should
one of the doors is open when the ignition switch is turned on or off. When
programming, press the transmitter Upper Left "Lock" Button to turn on the "Open
Door Bypass", or press the Upper Right "Unlock" Button to turn it off.
Feature #12 Doors Lock With Last Door Arming
This feature adds the automatic locking of the doors to the Last Door Arming
operation. If this feature is added to feature #4, when the system becomes armed 30
seconds after closing the last door the doors will also lock . This feature will operate
only if feature #4 is turned on. When programming, press the transmitter Upper Left
"Lock" Button to turn on the automatic door locking, or press the Upper Right
"Unlock" Button to turn it off.
)
Feature #13 Doors Lock With Automatic Rearming
This feature adds the automatic locking of the doors to the Automatic Rearming
operation. If this feature is added to feature #5, when the system rearms itself 90
seconds after being disarmed the doors will also lock. This feature will operate only
if feature #5 is turned on. When programming, press the transmitter Upper Left
"Lock" Button to turn on the automatic door locking, or press the Upper Right
"Unlock" Button to turn it off.
Feature #14 Ignition Activated Vehicle Recovery
This form of Vehicle Recovery is initiated by the ignition key being turned on. The
Vehicle Recovery operation, and the three ways to initiate it are described on page
17. When programming this feature, press the transmitter's Upper Left "Lock"
Button to turn it on, or press the Upper Right "Unlock" Button to turn it off.
Feature #15 Door Activated Vehicle Recovery
This form of Vehicle Recovery is initiated by a door being opened. The Vehicle
Recovery operation, and the three ways to initiate it are described on page 17. When
programming this feature, press the transmitter's Upper Left "Lock" Button to turn
it on, or press the Upper Right "Unlock" Button to turn it off.
(Factory Default Setting On)
(Factory Default Setting Off)
(Factory Default Setting Off)
(Factory Default Setting Off)
(Factory Default Setting Off)
Page 25