Crime Guard 328i4 Operation Manual page 9

case the system should also disarm. This feature configures the system to disarm
when Auxiliary Channel #2 is used, or to not disarm. When programming this
feature, pressing the transmitter's Upper Left "Lock" Button will have the system
disarm when Auxiliary Channel #2 is used; programming by pressing the Upper
Right "Unlock" Button will have the system remaining armed whenever Auxiliary
Channel #2 is used.
Feature #7 Parking Light Illumination Upon Disarm
This feature affects the parking light operation when the system is disarmed. When
this feature is turned on, the parking lights flash once, and then light continuously for
external illumination for 30 seconds unless the ignition key is turned on during that
time. If this feature is turned off, the parking lights flash once only, and do not
illuminate.
When programming, press the transmitter's Upper Left "Lock" button turns on
the added 30 second illumination; pressing the Upper Right "Unlock" Button has the
parking lights only flash once. This feature only affects the parking light operation,
and not the interior light operation which some Crime Guard models have.
Feature #8 Doors Lock When Ignition Is Turned On
This feature has the system automatically lock the vehicle's doors every time the
ignition key is turned on. An exception would be if feature #11 is turned on ("Open
Door Bypass of Automatic Locking"), and a door is open when the ignition key is
turned on. When programming, press the transmitter Upper Left "Lock" Button to
turn on automatic locking; or press the Upper Right "Unlock" Button to turn it off.
Feature #9 Doors Unlock When Ignition Is Turned Off
Similar to the previous feature, this feature automatically unlocks the vehicle's doors
every time the ignition key is turned off, with the same exception regarding a door
being open when the ignition is turned off, and feature #11 being on. On Crime Guard
models with "Driver Door Priority Unlocking", this feature may control all doors'
unlock operation, or only the driver's door. If the later, the next feature controls the
ignition key unlocking of the remaining doors.
When programming, press the transmitter Upper Left "Lock" Button to turn on
Unlock #1 When Ignition turned Off"; or press the Upper Right "Unlock" Button to
turn it off.
Page 24
(Factory Default Setting On)
(Factory Default Setting On)
(Factory Default Setting On)
Safety Disarm Feature
Pressing and releasing the Upper Right Unlock Button while the system is
activated in the alarm condition will disarm the system, but the doors will
not unlock. This is the "Safety Disarm" feature, which allows the vehicle
to remain secure, even though an activated system has been disarmed. Safety
Disarm will also cancel Automatic Rearming. This feature is also very
useful when the vehicle is exposed to environmental conditions, such as
storms, trains or heavy vehicles, which may cause false activations.
Safety Disarm is a temporary "one time" operation which occurs only
while the system is activated. To remotely unlock the doors after a Safety
Disarm, simply pressing and release the Upper Right "Unlock" Button again.
gain.
Activation Alert
If the system experiences an alarm condition and resets itself, upon disarming
the siren will chirp three times and the parking lights will flash three times
instead of the normal one chirp and one light flash. Additionally, the Status
Light will be flashing a "Zone Violation Code"; when the alarm condition
activation occurred, the Status Light changes from flashing slowly to
flashing two to four times between pausing to indicate which protected zone
was violated (see page 15 for the Zone Violation codes).
The Status Light will display the Zone Violation Code until the vehicle's
•
ignition is turned on.
The Status Light will display the Zone Violation Code in place of fast
•
flashes indicating Automatic Rearming.
Should the system be rearmed before the ignition clears the Zone Violation
•
Code memory, the Status Light shows the normal "Armed" slow flashing.
The system can store up to two consecutive Zone Violation Codes. If more
•
than two activations occurred, the two most recent codes are displayed.
Automatic Rearming:
Automatic Rearming is a programmable feature which ensures that your
system is never inadvertently disarmed. It is possible to accidentally or
unknowingly operate the transmitter from a pocket or purse. You may not
even be aware of an accidental disarming due to the enhanced operating
distance offered by Crime Guard's extended range transmitter.
How It Works
Whenever the system is disarmed by the transmitter, a 90 second countdown
starts, which is indicated by a rapidly flashing Status Light. During this 90
Page 9