Enhanced Remote Panic - Crime Guard 328i4 Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

PROGRAMMABLE FEATURES

This section explains each of the programmable features in detail, notes the

factory default setting, and includes programming information as needed..

Feature #1 SecureCode Emergency Override

SecureCode is a unique patented feature which allows you to custom select the

number of Valet Switch presses in two stages, instead of a single "1 press", which

would be required in order to perform an Emergency Override. If any of the three

anti-carjacking features are utilized, a customized SecureCode would also be

required to turn it off once it is fully activated.

How It Works

When a customized SecureCode has been programmed, when performing an

Emergency Override two separate stages of valet switch presses are required. Each

of these stages may be from 1 to 9 Valet Switch presses. The system will not disarm

after the initial Valet Switch entry, but pause and chirp the siren before continuing

to sound. At this point the stage #2 entry must be made within 10 seconds. If both

stages' entries are correct, the system will disarm shortly after the stage #2 entry.

After a failed attempt to achieve SecureCode, the ignition switch must be turned

off, then on again before another attempt is made. Should two failed SecureCode

attempts be made, the system will ignore any further presses of the Valet Switch for

two minutes. If this occurs, the system will reset to the armed state, then sound the

siren twice after 2 minutes to indicate that another attempt may be made to achieve

a SecureCode Emergency Override.

To custom program a new SecureCode:

Follow Steps 1 to 4 on page 20; at Step 4 the Valet Switch will be pressed and

released once (the siren chirps once) to access "feature number one".

Within 10 seconds slowly press and release the transmitter's Upper Left "Lock"

Button the number of times equal to the desired SecureCode for stage 1, allow the

system to respond to each transmitter button press with a siren chirp before

pressing the button again.

After entering the first stage by pressing the transmitter Upper Left "Lock" Button

the desired number of times, and receiving a chirp for each press, wait for the

system, after the final button press, to chirp the siren again the total number of

times that the button was pressed.

Continue

to configure stage 2 of the SecureCode by now pressing and releasing

the Upper Right "Unlock" Button the number of times desired for the stage 2.

This should be done in the exact same fashion as the stage 1 entry- press the Upper

Right "Unlock" button, wait for a single chirp before pressing the button again,

and then when final button press is done, wait after the single chirp for the siren

Page 22

(Factory Default

Setting 1 Press)

setting of "1 press", the system will disarm the moment the Valet Switch is

released from the single press. If a customized SecureCode has been

programmed, the system will disarm a few seconds after the correct entry.

If an incorrect entry is made, the system will not disarm. See page 22 for a

complete explanation of a customized SecureCode operation.

Valet Mode:

Whereas Emergency Override disarms an armed or sounding alarm, a

similar procedure is the Valet Mode, which basically turns the system "off",

and prevents it from arming or performing any automatic arming operations

which may be programmed to occur. Valet Mode is explained on page 14.

seconds

Upon Activating Panic:

ENTER THE VEHICLE

AND USE YOUR KEY TO

TURN THE IGNITION ON

If the SecureCode entry of the Valet Switch is the "as received" default