GE GeoSpring GEH50DEED Owner's Manual page 13

Anode Rod Maintenance and Service. GEA lia.ces.com
This information is intended to use by individuals possessing
adequate background of electrical, electronic and mechanical
experience. Any attempt to repair a major appliance
may result in personal injury and property damage. The
manufacturer or seller cannot be responsible for the
interpretation of this information, nor can it assume any
liability in connection with its use.
Tools needed:
. T20 Torx Screwdriver
. Slot Screwdriver
. Tape
. SocketWrench
. Socket Extention 12" long
.11/16" Socket
. Softset Sealant
. Anode Rod, if needed
* See page 72 for part ordering instructions
II1_
m
To service the Anode Rod:
1. Disconnect power, shut off the water supply, and partially
drain one or two gallons from the water heater through the
lower drain valve.
2. Removethe filter, trim ring, and front top cover as show in
Illustration A.
Trim Ring
Tape Process _,,,/_
Tube Pinch Off
Anode Rod T"£-.
Cover
Tape Corner
and Edges
4.. Using a slot screwdriver and ensuring to avoid damage to
exposed wires, remove foam to uncover the anode rod as
show in Illustration C,
Wires.
Anode Rod
iI1_ [_
5, Using a 1 1/16" s ocket and extension, unscrew the anode rod,
then lift out to inspect as show in Illustration D,
Anode Rod
fll_ [m]
3. Reinstallthe trim nng, place a protective layer of tape on sheet
metal edges, and remove the anode rod cover as show in
Illustration B,
6. To install the anode rod, seal the threads with soft set sealant,
thread into the port and using the torque wrench tighten to
50 +_ 5 ft-lbs of torque. Reinstallthe anode rod cover.
7. Turn water supply on, open a tap to remove any air in
plumbing system, inspect for leaks,then turn the power
on and reassemble the unit in reverse order as show in
Illustration A,
13