Craftsman 137.375640 Operator's Manual page 24

Fig.P
5
6
45 ° Right Bevel Positive Stop
Adjustment (Fig. Q)
1. Loosen the bevel lock handle (1) and
set saw arm at 45 ° angle.
2. Set the stop block at 45 ° position by
turning the lever (2) clockwise.
3. Tilt the cutting arm completely to the
right.
4. Using a combination square, check
to see if the blade is 45 ° to the table.
5. If the blade is not 45 ° to the miter
table, tilt the cutting arm to the left,
loosen the Iocknut (3), and turn
the bolt (4) in or out to increase or
decrease the angle.
6. Tilt the cutting arm back to the right,
and recheck alignment.
7. Repeat steps until the blade is 45 °
to the table. Once alignment is
achieved, tighten the Iocknut (3) to
secure the positive stop bolt.
Fig. Q
45 ° Left Bevel Positive Stop
Adjustment (Fig. R)
1. Loosen the bevel lock handle (1) and
set saw arm at 45 ° angle.
2. Set the stop block at 45 ° position
by turning the lever (2)
counterclockwise.
3. Tilt the cutting arm completely to the
left.
4. Using a combination square, check
to see if the blade is 45 ° to the table.
5. If the blade is not 45 ° to the miter
table, tilt the cutting arm to the right,
loosen the Iocknut (3), and turn
the bolt (4) in or out to increase or
decrease the angle.
6. Tilt the cutting arm back to the left,
and recheck alignment.
7. Repeat steps until the blade is 45 °
to the table. Once alignment is
achieved, tighten the Iocknut (3) to
secure the positive stop bolt.
Fig. R