Enabling Nview Dualview Mode After Initial Installation - Windows 2000; Using Nview Span Modes - Nvidia Quadro Workstation User Manual

Chapter 4
Using nView Multi-Display Settings
10When you have returned to your desktop, open the nView Display Settings page
and select Dualview from the nView Modes list.
Enabling nView Dualview Mode After Initial Installation —
Windows 2000
Switching back and forth between Dualview and Span/Clones mode under Windows
2000 is much faster after the initial Dualview installation session described in the
previous section. On subsequent Dualview enabling sessions, you can use fewer
steps, as follows:
1 From your Windows 2000 desktop, right click to view the Windows desktop
menu, then click Properties > Settings > Advanced and then the NVIDIA GPU tab.
2 Click nView Display Settings from the NVIDIA menu and select Dualview from
the nView modes list.
3 Follow the prompts to restart your computer.
4 When you have returned to your desktop, go to the nView Display Settings page
and select Dualview from the nView modes list.
Note: To switch back to Clone, Horizontal Span, Vertical Span, or, under certain

Using nView Span Modes

Note: nView Span modes do not apply under Windows 9x operating systems.
Note: You must have at least two displays connected to your computer to view the
Span mode settings.
nView horizontal and vertical Span modes treat multiple displays as a single large
desktop. In this mode, the desktop area is spread across both displays, however the
operating system treats both displays as one large display. For this reason, the refresh
rate, color depth, and resolution on both displays will be identical, and cannot be
changed independently. The desktop may be "stretched" horizontally or "stacked"
vertically, depending on your needs, as explained in "Using Horizontal & Vertical
Span Modes" on page
48
configurations, Single Display mode, you will need to restart your
computer, as prompted.
50.
User's Guide