Removing A Usb Flash Device; Connecting Timing Cables; Connecting Cables To The Bits Interface; Connecting Cables To A Gps Interface - Cisco ASR 903 Installation Manual

Chapter 3 Installing the Cisco ASR 903 Router
Figure 3-26

Removing a USB Flash Device

To remove and then replace a USB flash token memory stick from a Cisco ASR 903 Router, follow these
steps:
Step 1 Pull the memory stick from the USB port.
Step 2 To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM
as shown in
or removed regardless of whether the router is powered up or not.
Note
This completes the USB Flash memory installation procedure.

Connecting Timing Cables

The following sections describe how to connect timing cables to the Cisco ASR 903 Router:
•
•
When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling
Note
sufficient to allow for fan tray removal.

Connecting Cables to the BITS Interface

The following steps describe how to connect a cable to the router BITS port:
Confirm that the router is powered off.
Step 1
Connect one end of the cable to the BITS port using a straight-through, shielded RJ48C-to-RJ48C cable.
Step 2
OL-25178-03
Cisco ASR 903 Router Flash Token Memory Stick
Figure 3-26 . The Flash memory module can be inserted in only one way, and can be inserted
You can insert or remove the memory stick whether the router is powered on or not.
Connecting Cables to the BITS Interface, page 3-39
Connecting Cables to a GPS Interface, page 3-41
Connecting the Cisco ASR 903 Router to the Network
M E M
C O N S O L
E
Cisco ASR 903 Router Hardware Installation Guide
3-39