Powering Up The Cisco Asr 903 Router - Cisco ASR 903 Installation Manual

Powering Up the Cisco ASR 903 Router

Powering Up the Cisco ASR 903 Router
Make certain that all card slots and compartments are closed off. Install blank faceplates on any empty
slots. Always have power supply slots filled. If you leave a power supply slot uncovered, then you risk
exposure to hazardous voltages on the power pins on the midplane.
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
After installing your Cisco ASR 903 Router and connecting cables, start the router and follow these
steps:
Activate the DC power supply using the steps described in
Step 1
on page
Caution
Note
Observe the initialization process. When the system boot is complete (the process takes a few seconds),
Step 2
the Cisco ASR 903 Router RSP begins to initialize.
Example 4-1
Cisco ASR 903 Router Hardware Installation Guide
4-2
3-26.
Do not press any keys on the keyboard until the messages stop and the SYS PWR LED is solid
green. Any keys pressed during this time are interpreted as the first command typed when the
messages stop, which might cause the router to power off and start over. It takes a few minutes
for the messages to stop.
This is only an example of what can display. The system boots differently depending upon
the configuration that ships with your system.
Loading the Default System Boot Image
rommon 1 >
rommon 1 > boot
Located rp_super.ppc.nader.5g.evfc.bin
Image size 211681484 inode num 12, bks cnt 51681 blk size 8*512
######################################################################################
#
#############################################
Boot image size = 211681484 (0xc9e00cc) bytes
Using midplane macaddr
Package header rev 0 structure detected
Calculating SHA-1 hash...done
validate_package: SHA-1 hash:
calculated 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34
expected 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34
Image validated
PPC/IOS XE loader version: 0.0.3
loaded at: 00800000 0D1E2004
zimage at: 00807673 009B8C69
Chapter 4 Cisco ASR 903 Router Initial Configuration
"Activating the DC Power Supply" procedure
OL-25178-03