Patrol Sequence Window - Cisco 4300E User Manual

Feature Setup Windows
Table 3-7
Option
Password
Enable Passive Mode
Secondary FTP Server
Secondary FTP Port
User Name
Password
Enable Passive Mode
Upload Snapshot
Upload Video Clip

Patrol Sequence Window

The Patrol Sequence window provides options for configuring a patrol sequence for the IP camera. A
patrol sequence consists of up to eight steps, each of which causes the camera to move to a designated
preset position and remain in the position for a designated time.
When you create a patrol sequence, you define the order of the steps. When the patrol sequence runs, the
IP camera goes to the preset position that is defined by the first step, then moves through each preset
position in the configured order. It stops at the preset position that is defined by the last step.
Before you can configure a patrol sequence, you must define preset positions as described in the
controls"
sequence.
To display the Patrol Sequence window, access the configuration windows as described in the
"Performing the Initial Setup of the IP Camera" section on page
Patrol Sequence.
If you change any options in this window, you must click the Save Settings button to save the change.
If you do not click this button, changes are not retained when you exit the window. Save Settings appears
at the bottom of the window. You may need to scroll down to it.
Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide
3-16
Event Notification Window Options (continued)
Description
Enter the primary FTP server login password.
Check this check box to enable the passive mode feature of the primary FTP
server.
Identify an optional secondary FTP server to which snapshots or video clips
are uploaded by choosing IP Address or Hostname from the drop-down list
and entering the IP address or host name in the corresponding field.
Enter the port number that receives messages on the secondary FTP server.
The default FTP port number is 21.
Enter the secondary FTP server login user name.
Enter the secondary FTP server login password.
Check this check box to enable the passive mode feature of the secondary
FTP server.
Check this check box to upload a snapshot of the activity that triggered the
event.
This functionality is available only when the secondary video stream is
enabled.
Check this check box and enter the following values to upload a video clip
of the activity that triggered the event:
• Pre-Capture Length—Enter the amount of video (in seconds) before
the event to include in the video clip. The default pre-capture length is
0 seconds (no pre-capture video).
Post-Capture Length—Enter the amount of video (in seconds) after the
•
event to include in the video clip. The default post-capture length is 5
seconds.
rows in Table 4-1. These rows also explain how to start and stop the execution of a patrol
Chapter 3 Configuring and Managing the IP Camera
2-5, click Feature Setup, then click
"Presets
OL-25230-02