Event Notification Window - Cisco 4300E User Manual

Feature Setup Windows
To display the Event Notification window, access the configuration windows as described in the
"Performing the Initial Setup of the IP Camera" section on page
Event.
If you change any options in this window, you must click the Save Settings button to save the change.
If you do not click this button, changes are not retained when you exit the window. Save Settings appears
at the bottom of the window. You may need to scroll down to it.
Table 3-7
Table 3-7
Option
Event Triggering Area
Triggered by
Actions
Interval
Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide
3-12
describes the option in the Event Notification window.
Event Notification Window Options
Description
Check the desired check boxes to designate the events that trigger actions:
Input 1—Event is triggered when input port 1 on the IP camera changes
state from high to low.
Input 2—Event is triggered when input port 2 on the IP camera changes
state from high to low.
Motion Detection—Event is triggered when the camera detects motion, if
motion detection is configured as described the
rows in Table
Video Loss—Event is triggered if the IP camera loses input to its codec
sensor module.
Check the desired check boxes to designate that actions that the IP camera
takes when the corresponding trigger occurs.
Email—Sends information about the event in an e-mail message to the
•
designated recipient. You design the recipient and configure other
e-mail options in other fields in this window.
• Output 1—Changes the state of the output 1 port on the IP camera as
defined in the Port Settings window.
Output 2—Changes the state of the output 2 port on the IP camera as
•
defined in the Port Settings window.
Syslog—Sends information about the event to a designated Syslog
•
server.
HTTP—Sends information about the event as an HTTP stream to a
•
remote system.
FTP—Uploads a snapshot or video clip of the event to an FTP server.
•
Choose the time interval (in minutes) from the drop-down list to wait after
an event occurs before detecting the next event.
Chapter 3
2-5, click Feature Setup, then click
4-1.
Configuring and Managing the IP Camera
"Motion detection controls"
OL-25230-02