Cisco UCS C220 Installation And Service Manual page 84

Installing or Replacing Server Components
Install a Cisco Flexible Flash card:
Step 2
Note
Note
a. Insert the Cisco Flexible Flash card into the slot with the label side facing outward.
Note
b. Press down on the top of the card until it clicks in the slot and stays in place.
c. Replace the top cover.
d. Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
Cisco UCS C220 Server Installation and Service Guide
3-44
To be usable for Cisco Flexible Flash, an SD card must be at least 16 GB in size.
Any SD card that is installed into the Cisco Flexible Flash slot is configured with the VD
partitioning described in Overview of the Pre-Installed Cisco Flexible Flash Card, page
This overwrites data on the SD card where Cisco stores the configuration metadata.
Dual cards are supported only with CIMC 1.5(1) or later. With releases earlier than CIMC 1.5(1),
only a single card is supported and it must be in slot SD1 (see
Chapter 3 Maintaining the Server
3-40.
Figure 3-23).
OL-25760-01