Cisco Flexible Flash Card Replacement Procedure - Cisco UCS C220 Installation And Service Manual

Chapter 3 Maintaining the Server

Cisco Flexible Flash Card Replacement Procedure

To install or replace a Cisco Flexible Flash card, follow these steps:
Step 1 Remove the Cisco Flexible Flash card that you are replacing. See
a.
b.
Caution If you cannot safely view and access the component, remove the server from the rack.
c.
d.
e.
f.
g.
OL-25760-01
Power off the server as described in the
page 3-7.
Slide the server out the front of the rack far enough so that you can remove the top cover. You might
have to detach cables from the rear panel to provide clearance.
Remove the top cover as described in
page 3-8.
Locate the Cisco Flexible Flash card that you are replacing on PCIe riser 2. See
Push down on the top of the Cisco Flexible Flash card, then release it to allow it to spring up in the
slot.
Remove the Cisco Flexible Flash card from the slot.
Wait 10 seconds for the Cisco Flexible Flash management software to recognize and react to the
absence of the card.
Installing or Replacing Server Components
Figure
"Shutting Down and Powering Off the Server" section on
"Removing and Replacing the Server Top Cover" section on
Cisco UCS C220 Server Installation and Service Guide
3-23:
Figure 3-23.
3-43