Cisco UCS C220 Installation And Service Manual page 125

Hide thumbs Also See for UCS C220:
Table of Contents

Advertisement

Appendix C
RAID Controller Considerations
Note
Press Enter.
Step 10
The prompt asks whether you have a driver disk.
Step 11
Use the arrow key to select Yes, and then press Enter.
Step 12
Select fd0 to indicate that you have a floppy diskette with the driver on it.
Do one of the following actions:
Step 13
The installer locates and loads the driver for your device. The following message appears:
Loading megasr driver...
Follow the Red Hat Linux installation procedure to complete the installation.
Step 14
Reboot the system.
Step 15
Installing the SUSE Linux Enterprise Server Driver
For the specific supported OS versions, see the
server release.
This section describes the installation of the SuSE Linux Enterprise Server driver on a system with the
embedded MegaRAID stack.
Us e the following procedure to install the SLES drivers.
Create a RAID drive group using the LSI SWRAID Configuration utility before you install this driver
Step 1
for the OS. Launch this utility by pressing Ctrl+M when LSI SWRAID is shown during BIOS post.
Step 2
Prepare the dud.img file using one of the following methods:
Extract the dud.img file:
Step 3
a.
b.
c.
Step 4
Start the Linux driver installation using one of the following methods:
OL-25760-01
The noprobe values depend on the number of drives. For example, to install RHEL 5.7 on a
RAID 5 configuration with three drives, enter: 
Linux dd blacklist=isci blacklist=ahci noprobe=ata1 noprobe=ata2 noprobe=ata3
If you prepared the IMG file on a physical diskette in
to the target server and then insert the diskette in the A:/ drive and press Enter.
If you mapped the IMG file as a virtual floppy in
To install from a physical diskette: Use one of the procedures in
Diskettes For Linux, page
Then return to
Step 4
of this procedure.
To install from a virtual floppy disk: Download and save the Cisco UCS C-Series drivers ISO, as
described in
Downloading the LSI MegaSR Drivers, page
Then continue with the next step.
Burn the ISO image to a disc.
Browse the contents of the drivers folders to the location of the embedded MegaRAID drivers:
/<OS>/Storage/Intel/C600/
Copy the dud-<
driver version
Step
Step
Hardware and Software Interoperability Matrix
C-14. 
>.img file to a temporary location on your workstation.
Cisco UCS C220 Server Installation and Service Guide
Embedded MegaRAID Controller
2: Connect an external USB diskette drive
5: Select the location of the virtual floppy.
Preparing Physical Installation
C-12. 
for your
C-17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ucs c220 m3

Table of Contents