Rear Panel Leds And Buttons; Figure; Table; Led Name - Cisco UCS C220 Installation And Service Manual

Status LEDs and Buttons

Rear Panel LEDs and Buttons

Figure 3-2

Figure 3-2
1
1
2
3
4

Table 3-2

Rear Panel LEDs, Definitions of States

LED Name

Power supply fault
Power supply status
1-Gb Ethernet dedicated
management link speed
Cisco UCS C220 Server Installation and Service Guide
3-4
shows the rear panel LEDs and buttons.

Rear Panel LEDs and Buttons

PSU1 PSU1 PSU1
2
Power supply fault LED
Power supply status LED
1-Gb Ethernet dedicated management link
status LED
1-Gb Ethernet dedicated management link
speed LED
State
Off—The power supply is operating normally.
•
Amber, blinking—An event warning threshold has been reached, but the power
•
supply continues to operate.
Amber, solid—A critical fault threshold has been reached, causing the power
•
supply to shut down (for example, a fan failure or an over-temperature condition).
AC power supplies:
• Off—There is no AC power to the power supply.
• Green, blinking—AC power OK, DC output not enabled.
• Green, solid—AC power OK, DC outputs OK.
DC power supplies:
• Off—There is no DC power to the power supply.
• Green, blinking—DC power OK, DC output not enabled.
• Green, solid—DC power OK, DC outputs OK.
Off—link speed is 10 Mbps.
•
Amber—link speed is 100 Mbps.
•
Green—link speed is 1 Gbps.
•
Table 3-2
PSU2 PSU2 PSU2
5
1-Gb Ethernet link speed LED
6
1-Gb Ethernet link status LED
7 Rear Identification button/LED
–
Chapter 3 Maintaining the Server
defines the LED states.
3 4 5 6 7
OL-25760-01