Advertisement
Care & Cleaning
To clean the burner
head ignition ports:
Each burner
head
has a small ignition port
located
as shown.
Should you experience
ignition
problems
it may be that this port
hole is partially
blocked
with soil. With
the burner
head in
place, use a small wire gauge
needle or the end of a paper
clip
to clear
the ignition
port (Refer to Figure 40; round style shown;
oval burner on some models
not shown).
Important
notes:
•
The surface
burner
heads are secured
to the cooktop
and
must be cleaned
in place on the cooktop.
•
Always
keep the surface
burner
caps in place whenever
a
surface
burner is in use.
•
When
replacing
the burner caps, be sure the burner
caps
are seated firmly
on top of the burner
heads.
•
For proper
flow
of gas and ignition
of burners do not allow
spills, food,
cleaning
agents
or any other
material
to enter
the gas orifice
port opening.
Replacing
Oven Light (some models)
The oven light is located
at the rear of the oven cavity
and is
covered
with a glass shield
held by a wire holder.
The glass
shield protects
the light bulb and must be in place whenever
the
oven is in use.
glass
shield
wire
holder
Figure 41: Replacing
the oven light
To replace
the interior
oven light bulb:
Be sure the range
is unplugged
and all parts
are cool before
replacing
oven light. Wear
a leather-faced
glove for protection
against
possible
broken
glass.
1.
Turn electrical
power off at the main source or unplug
the
range.
2.
Press wire holder
to one side to release the glass shield that
covers the light bulb.
3.
Replace
light with a new 40 watt
appliance
bulb.
4.
Replace
glass shield over bulb and snap wire holder
back
into place.
5.
Turn power
on at the main source (or plug the appliance
in).
6.
The clock
will then need to be reset. To reset, see "Setting
Clock"
on page
16.
33
Advertisement
