Advertisement
Oven
Controls
Important
notes:
•
Always
start with hot food
when using the warmer
drawer.
Do not heat cold food
in the warmer
drawer.
•
Self Clean
can not be set when the warmer
drawer
is active.
•
The warmer
drawer
is equipped
with a catch
that may
require
extra
force
to open and close the drawer.
Removing and Replacing
the Warmer
Drawer
To remove the warmer drawer:
Electrical
shock hazard
can occur and result in
serious injury or death.
Disconnect
appliance
from electric
power
before
cleaning
and servicing
the warmer
drawer.
1.
Turn power
OFF to the appliance
before
removing
the
warmer
drawer.
2.
Open
the warmer
drawer
completely.
3.
On left warmer
drawer
rail, locate
black
release
lever and
press up with finger
while pulling
out slightly
on the oven
drawer
handle.
On right warmer
drawer
rail, locate
black
release
lever and press down with finger
while pulling
out
slightly
on the warmer
drawer
handle
(See Figure 36).
Left-hand
rail
and
release
\
4.
The warmer
drawer
should
now be released
from the rails.
Remove warmer
oven drawer
(using level and square
motion)
completely
out and away
from the appliance.
To replace
the warmer
drawer:
1.
Pull the bearing
glides
to the front
of the outer compart-
ment glide channels
until they snap into place
(See
Figure 37).
Figure 37:
Bearing
glide placement
2.
Carefully
line up both sides of the warmer
drawer
glide
rails to the outer compartment
glide channels
located
inside
the empty
warmer
drawer
compartment
(See Figure 38).
Warmer
drawer'
handle
Figure 36:
Right-hand
rail and release
Removing
the warmer
drawer
Figure 38:
Channel
alignment
3.
While
holding
the warmer
drawer
level and square
using
the warmer
drawer
handle,
push (do not force)
the warmer
drawer
all the way into the outer compartment
glide
channels
all the way into the range. Open
the warmer
drawer
again
to verify
the glides
have seated.
4.
If you do not hear the levers "click"
or the bearing
glides do
not feel seated remove
the warmer
drawer
and repeat
Steps 1 through
3 again.
This will minimize
possible damage
to the bearing
glides.
28
Advertisement
