Furuno FR-2115-B Installation Manual page 51

8. Run the connector from the card case in front of the GYRO CONVERTER Board as shown
in Figure 4-12.
9. Plug the connector from the M-card base assy. in J1 on the RP Board as shown in Figure
4-12.
INT Board
RP Board
ARP Board
SPU Board
Route cable between ARP and SPU Boards.
10. Fasten the ground wire from the connector with M3X8 pan-head screw and teethed lock
washer at the location shown in Figure 4-12.
11. Fasten the PCB card case cover to the processor unit.
12. Connect the monitor cable to the RGB Board. Close the processor unit.
GYRO
CONVERTER
Board
Fasten ground wire from connector with this screw.
(TOP VIEW)
J1
(FRONT VIEW)
Figure 4-12 Processor, front and top views
RP connector
4-12
FRONT