Furuno FR-2115-B Installation Manual page 41

4. Connect the GYRO CONVERTER Board to the INT Board (cables supplied with GC-8) as
shown below.
5. Confirm gyrocompass specifications and set the DIP switches and jumper wires on the
GYRO CONVERTER Board according to the gyrocompass connected:
Setting jumper wires and DIP switches by gyrocompass specifications: page 4-4
Setting jumper wires and DIP switches by make and model of gyrocompass: page 4-5
Location of jumper wires and DIP switches: page 4-6
6. Solder the gyrocompass cable to the VH connector assemblies (supplied).
7. Attach instruction label (supplied) to shield cover for the INT and GYRO CONVERTER
boards.
8. Close both the INT Board cover and the processor unit cover.
9. Turn the power off and on again to reset the CPU.
INT Board GYRO CONVERTER Board
J446 (4P)
J465 (6P)
J446
J465
INT BOARD
03P9252
GYRO CONVERTER
BOARD 64P1106
Figure 4-2 Processor unit, inside view
J7 (5P)
J1 (14P)
J5
To gyro
J4
J7
J1
Fix cable to chassis
with cable tie.
4-2