Furuno FR-2115-B Installation Manual page 45

Location of DIP switches, jumper wires on the GYRO CONVERTER Board
JP2
(Rotor voltage)
JP3
(Stator voltage)
JP1
(Gyro type)
Fuse
(2A)
J5
(Rotor signal input,
external power input)
4.1.3 Setting the heading readout on the radar display
Confirm that the gyrocompass is giving a reliable readout. Then, set the heading readout on the
monitor as follows:
1. Press the [RADAR MENU] key to display the FUNCTIONS 1 menu.
2. Press the [0] key twice to display the FUNCTIONS 3 menu.
3. Press the [9] key to select the GYRO SETTING option.
4. Rotate the EBL control to align the radar's HDG readout with the gyrocompass heading.
5. Press the [ENTER] key to finish.
JP5, JP4
(Supply voltage)
SW1
J4
DIP switch
(Stator signal input)
(IEC-61162-1 output port)
Figure 4-4 GYRO CONVERTER Board
4-6
64P1106
J8
J6
(Data output port #2)
J7
(Data output port #1)
J12
(Data output
port #6)
J11
(Data output
port #5)
J10
(Data output
port #4)
SW2
DIP switch
JP6, JP7
(AD formal
data Tx interval)
J9
(Data output port #3)