Advertisement
DIAGRAM OF THE CONSOLE
Displays
INSERT KEY
RESE'r SPEED
SE'I" SPEED
ON
OFF
Note: If there is a thin sheet
"_ a_ _,
_"
of clear plastic on the face
L._9 J_J
of the console, remove it.
17
• Clip "
__{Key
Incline Buttons
_..-..=
Pulse Sensor •
8
If the key is in the console, remove it. Make sure that
the power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORDon page-7:)_
Next, step onto the foot rails of the treadmill. Find the
.clip attached to the key (see the drawing abo_,e), and
slide the dip onto the waistband of your clothing.
Follow the steps below to operate the console:
B
Insert the key fully into the power switch.
The four displays •
and the green man-
ual mode
indicator will light..
STEP-BY-STEP
CONSOLE OPERATION
The treadmill console features a manual mode and four
preset workout programs. In the manual mode, the
.
speed of the walking belt can be changed with the elec-
tronic speed control. When one of the preset programs
is selected, the console .will automatically control the
speed as it guides you through an effective workout.
Before operating the
console, make sure
thatthe on/off switch
near the power cord
is in the =on" position.
B
• B
=On"
Position
Reset the speed control.
Slide the speed control down to
the "RESET=position. Note:
Each time the walldng belt Is
stopped, the speed control
must be moved to the
"RESET" position before the
walking belt can be. restarted.
Set a speedsetttng.
Refer to the drawing above. Slide the speed control
upward to set a speed setting. Note: If the key was
just Inserted, the walking belt will not begin to
move yet.
Advertisement
