Advertisement
4. With the help of a second person, carefully lower the Left
and Right Uprights (1,44) until the handrails are resting
on the floor.
1
Attach six Base Pads (57) to the bottom of the Base (59)
in the indicated locations. Note: One extra Base Pad
may be included.
See drawing 4 above. With the help of a second person,
raise the Left and Right Updghts (1,44)
until the Base
(59) is resting fiat on the floor.
Before moving the treadmill, see HOW TO MOVE THE
TREADMILL on page 11.
6. Insed two Resistance Bracket Bolts (107) with Bracket
WasherS (70) into the Left Updght (.1). Slide two Star
Washers.(.€03), a_,p_.r..(106),
,andtwo more Star
•Washers (103) onto the Bolts. Make sure that the
Spacer is turned so the widest slde is facing the Left
UpdghL Tighten the Bolts into the Resistance Bracket
(104) at the lower end of the left Upper Body Arm (96).
(Note: It may be necessary to loosen the Resistance
Knob [97] and pivot the Resistance BmckeL)
Attach the right Upper Body Arm (96) as desqdbed
above. Make sure that both Upper Body Arms are on the
correct side of the Console Base (9) as shown.
See drawing 2 on page 5. Feed the slack Wire Hameas
(25) into the Base (59).
7. Remove the backing from the Adhesive Clip (7"/). Press
the Adhesive Clip onto the Rear Roller Endcap (78) in the
"
indicated location. Press the Allen Wrench (76) into the
Adhesive Clip.
Make sure that all parts are tightened before you use the
treadmill. Note: To protect the floor or carpet, place a
mat under the treadmill. For Information
On ordering a
mat, see REPLACEMENT
PARTS on the back cover.
4
6
76
Advertisement
