Advertisement
4. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking bell has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the 3/16" end of the allen
wrench, tum the left rear roller adjustment bolt clockwise, and
the dght bolt counterclockwise, 1/4 of a turn each. Be careful not
to overtighten the walking belt. Plug in the power cord, insert the
key and run the treadmill for a few minutes. Repeat until the
walking belt is centered.
a
b. ff the walking belt has shifted to the right, first remove the key
and UNPLUG THE POWER CORD. Using the 3/16" end of the
alien wrench, tum the left rear roller adjustment bolt counter-
clockwise, and the dght bolt clockwise, 1/4 of a turn each. Be
careful not to overtighten the walking bell Plug in the power
cord, insert the key and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b
c. If the walking belt slips when walked on, first remove the key
and UNPLUG THE POWER CORD. Using the 3/16" end of the
allen wrench, turn both rear roller adjustment bolls clockwise,
1/4 of a turn. When the walking boll is correctly tightened, you
should be able to lift each side of the walldng belt 2-3 inches off
the walking platform. The center of the walking bolt should just
touch the walking platform. Be careful to keep the walking bell
centered. Plug in the power cord, Insert the key and run the
•treadmillfor a few minutes. Repeat until the walking belt is prop-
edy tightened.
5. SYMPTOM: THE TREADMILL SITS UNEVENLY ON THE FLOOR
a. Make sure that the six base pads are attached to the treadmill (see assembly step 5 on page 6).
6. SYMPTOM: ONE OF THE UPPER BODY ARMS SQUEAKS DURING USE
a. Correcting this problem requires a small amount of white madne grease, available at most hardware stores.
Turn the Resistance Knob (97) counterclockwise
until ltcan be
removed. Remove the I_esistance Cone (98) and the Upper
Body Arm (96), along with the 3/8" Washers (67), Spdng
Washer (5), Thrust Washers (101 ), and Thrust Beadng (102).
(Note: If the Resistance Sleeve [99] comas out of the
Resistance Bracket [lo4], press It back In.) Apply a thin layer of
white rnadne grease to the outer surface of the Resistance Cone
(98). Reattach all parts in the order shown at the dghL
104
101
Advertisement
