Table of Contents
Advertisement
TROUBLESHOOTmNG
Most treadmill
tsroblems can be sotvod by following
the steps below. Find the symptom
that applies, and
fottow the stops tistod, mffurther assistance
is needed, please see the front covor of this manual.
PROBLEM:
The power doos not turn on
SOLUTmON: a, Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 10). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 10. important: The treadmill is not com-
patible with GFCI-equipped
outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
C,
Check the reset/off circuit breaker located on the
treadmill frame near the power cord. if the switch
protrudes as shown, the circuit breaker has
tripped. To reset the circuit breaker, wait for five
minutes, and then press the switch back in.
Tripped
Reset
PROBLEM:
The power turns off during
use
SOLUTION:
a. Check the reset/off circuit breaker (see the drawing above), if the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. if the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. if the treadmill still will not run, see the front cover of this manual.
PROBLEM:
The incline of the treadmill
doos not chango correctly
SOLUTmON: a, With the key in the console, pross one of the Incline buttons, While the incline is changing,
re-
move the key. After a few seconds, re-insert the key. The treadmill will automatically
rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
PROBLEM:
The display of the consoto
does not function
property
SOLUTION:
a, Remove the key from the console and UNPLUG THE
POWER CORD. With the help of a second person,
carefully tip the Uprights (84) down as shown. Next,
remove the three Screws (3) and the three Hood
Screws (7). Note: A phillips screwdriver with a shaft at
bast 5" long is required.
84
22
Advertisement
Table of Contents
