Table of Contents
Advertisement
2, Withthehelpof a second person, c arefully raise the
Uprights (84)toa vertical p osition,
Have thesecond person holdtheconsole assembly n ear
the Uprights ( 84),Lookunder theconsole assembly a nd
locate theConsole W ireHarness ( 78),
Cuttheplastic tiessecuring the Upright WireHarness
(77)totherightUpright ( 84),Next, c onnect t heUpright
WireHarness totheConsole WireHarness ( 78),Make
sureto connecttheconnectorsproperly(seethe
insetdrawing).TheconnectorsshouldsJide together
easity and snap into place, if they do not, turn one con-
nector and then try again, mF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER mSTURNED ON.
Console
Assembly.
78
"" 77
insert the Wire Harnesses (77, 78) down into the right
Upright (84),
Set the console assembly on the Uprights (84). Be care-
fui to avoid pinching
the Wire Harnesses
(77, 78).
While a second person holds the console assembly, at-
tach it with four Console Bolts (64) and four Star Washers
(8) as shown; start aH four Console
BoJts and then
firmly tighten them.
3
Console
t--84
84_I
Press the Latch Housing (73) into the left Upright (84).
Tap the Latch Housing with a rubber mallet if necessary.
Remove the knob from the pin, Make sure that the collar
and the spring are on the pin, (Note: if there are two col-
lars, place one on each side of the spring,) Next, insert
the pin into the Latch Housing (73), Then, tighten the
knob back onto the pin,
Hug in the power cord as described on page 10, and
then turn on the power as described on page 12, Note:
The treadmill may automatically
rise to the maximum in-
cline level and then return to the minimum level,
Knob
Pin
Advertisement
Table of Contents
