ProForm 750 PFTL73105.5 User Manual page 8

Hace the treadmHUin the storage position (see HOW TO
FOLD AND MOVE THE TREADMILL on page 20),
Next, pUacethe cylinder end of the Gas Spring (92) near
the bracket on the base of the Uprights (84),
See the two small inset drawings, Using your fingernail
or the end of a screwdriver, press on the end of the
Spring Pin (25) to loosen it from the Gas Spring (92),
Next, rotate the Spring Pin and remove it, Be ¢arefuJ to
avoid Josing the Spring Pin. Note: Extra Spring Pins
are included,
See drawing 5a, Press the cylinder end of the Gas
Spring (92) onto the ball on the bracket, Next, insert the
end of the Spring Pin (25) through two of the small hobs
in the end of the Gas Spring, Then, rotate the Spring Pin
until it clips onto the Gas Spring,
Cylinder _._
Raise the Gas Spring (92) to a vertical position, Remove
the Spring Pin (25) from the raised end of the Gas Spring
as described in step 5, if necessary, rotate the Gas
Spring to align the end of the Gas Spring with the ball on
the bracket on the Frame (58),
Next, press the Incline buttons on the Console (not
shown) until the ball on the bracket is aligned with end of
the Gas Spring (92), Then, press the end of the Gas
Spring onto the ball, Note: it may be necessary to press
the end of the Gas Spring onto the ball while the Frame
is moving,
See drawing 6a, insert the Spring Pin (25) into the two
indicated small hobs in the end of the Gas Spring (92),
Then, rotate the Spring Pin until it clips onto the Gas
Spring,
Press the Incline decrease button until the treadmill is at
the lowest incline level, Then, unplug the power cord,
6a
Bracket
7, Make sure that aH parts are properly tightened before you use the treadmill, if there are sheets of clear
plastic on the treadmill decals, remove the plastic, To protect the floor or carpet, place a mat under the tread°
mill, Note: Extra hardware may be included, Keep the included allen wrench in a secure place; the large allen
wrench is used to adjust the walking belt (see page 23),
8