Table of Contents
Advertisement
With the heUpof a second person, carefully raise the
Uprights (84) to the position shown, Carefully pivot the
Hood (41) off,
41
Locate the Reed Switch (63) and the Magnet (46) on
the left side of the Pulley (47), Turn the Pulley until the
Magnet is aligned with the Reed Switch, Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". if necessary, loosen the Screw
(3), move the Reed Switch slightly, and then retighten
the Screw, Reattach the Hood (not shown), and run
the treadmill for a few minutes to check for a correct
speed reading,
PROBLEM:
The walking
belt slows when walked on
Top
View
SOLUTION:
a, Use only a single-outlet surge suppressor that meets all of the specifications described on page 10,
b,
if the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged, Remove the key and UNPLUG THE
POWER CORD, Using the allen wrench, turn both
rear roller bolts counterclockwise,
1/4 of a turn, When
the walking belt is properly tightened, you should be
able to lift each edge of the walking belt 2 to 3 inches
off the walking platform, Be careful to keep the walk-
ing belt centered, Then, plug in the power cord, insert
the key, and run the treadmill for a few minutes,
Repeat until the walking belt is properly tightened,
Rear Roller Bolts
c, if the walking belt still slows when walked on, see the front cover of this manual,
PROBLEM:
The waJking belt is off-center
or stips when walked on
SOLUTION:
a, If the waIMng belt is off-center,
first remove the key
and UNPLUG THE POWER CORD, mfthe walking
belt has shifted to the left, use the allen wrench to
turn the bft rear roller boutcbekwbe
1/2 of a turn; if
the walking
belt has shifted to the right, turn the
left bolt counterclockwise
1/2 of a turn, Be careful not
to overtighten the walking belt, Then, plug in the
power cord, insert the key, and run the treadmill for a
few minutes, Repeat until the walking belt is centered,
b,
If the walking
beJt slips when waJked on, first re-
move the key and UNPLUG THE POWER CORD,
Using the allen wrench, turn both rear roller bolts
clockwise, 1/4 of a turn, When the walking belt is cor-
rectly tightened, you should be able to lift each edge
of the walking belt 2 to 3 inches off the walking plat-
form, Be careful to keep the walking belt centered,
Then, plug in the power cord, insert the key, and care°
fully walk on the treadmill for a few minutes, Repeat
until the walking belt is properly tightened,
23
Advertisement
Table of Contents
