Quick Start Function - Canon LEGRIA HFR16 Instruction Manual

• In mode, you can also set
constant speeds (3 is the fastest, 1 the slowest).
• When [Zoom Speed] is set to [
faster in record pause mode than when actually recording, except when
pre-recording (

Quick Start Function

When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel, the camcorder is ready to start recording in approximately
1 second*, allowing you to record the subject right away.
* The actual time required varies depending on the shooting conditions.
Operating modes:
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
2 When you wish to resume recording, open the LCD panel.
The ON/OFF (CHG) indicator turns back green and the camcorder is
ready to record.
IMPORTANT
• Do not disconnect the power source during standby mode (while the
ON/OFF (CHG) indicator is lit in orange).
NOTES
• The camcorder will not enter standby mode if the LCD panel is closed
while the ACCESS indicator is on or flashing, while a menu is being dis-
played, or while the PHOTO button is pressed down halfway. The cam-
corder may also not enter standby mode if the LCD panel is closed
while the memory card slot cover is open or when the battery charge is
too low. Check that the ON/OFF (CHG) indicator changes to orange.
40
Video
56) is activated.
[Zoom Speed] to one of three
Variable], the zoom speed will be