Error Code; Error Type - Kenmore 407.53550 Use & Care Manual

Prob!_,n
Dehumidifier runs too
much
Frost appears on the
coils
, ijlllll i
The controls cannot be
set or changed
iiiiiiiiiiiiiiiiii1'11, ii iii iiiii ii
Fan Noise
Water on the floor
Posdble Causes
HII IIIII I I I II IHIIIII I IIIII I I I I I I I I I
The area to be dehumidified
is too large.
Doors and windows are
open.
The dehumidifier has recent-
ly been turned on or the
room temperature is below
41°F.
IIII I I I I I
Bucket is full or it has been
removed.
,w. ,. q, • , i
Air is moving through the
unit.
Hose connection may be
loose.
Hose is attached but not
draining into a drain.
Solutions
i.l.,i i
The capacity of your dehumidifier may not
be adequate for the room size.
i ill i
Close all doors and windows to the outside.
This is normal. Frost wilt usually disappear
within 60 minutes.
i.i I..H..I .I
Empty bucket and install properly in unit.
This is normal.
Check the hose connection. See the Drain-
age Section.
,,,,Luu, ,, i i
Check hose for obstruction.
Error Code
n
Error Type
Ambient Tem-
perature Sensor
Malfunction
Possible Cause
1. Sudden Change in
the surrounding
temperature.
2. Faulty Sensor
Corrective Action
i iii [ i i
1. Unplug the dehumidifier.
2. Check the surrounding area for
possible reasons for sudden
temperature changes.
3. Wait 30 minutes before plug-
ging the dehumidifier bgck in
for normal operation.
F2
Evaporative
Coil Tem-
perature
Sensor Mal-
function
.
if the "Error" is still indicated,
please contact your nearest
service center. Call 1-
800-488-1222 for service center
locations.
12