Turningon Theappliance; Dishwasher Accessories - Danby Silhouette DDW2405W Instruction Manual

TURNINGON THEAPPLIANCE
Starting a wash cycle...
,
Pull out the upper and lower dish racks, load the
dishes according to the diagrams outlined on page 8
and return the dish racks back to their original
position inside the dishwasher.
2. Close the door and listen for the door latch to click,
signifying the door is locked. If the door is not prop-
erly closed, the dishwasher will not operate and the
message "DOOR OPEN" will appear in the LCD dis-
play once the power is turned on. Open and close
the door again, applying a little force if necessary.
3. Press the ON/OFF button.
4. Select the desired wash program (using the program
button) and adjust temperature according to the size
and soil conditions of the dishes.
Changingthe Program
To change from one wash program to another wash
program during operation, follow these steps;
1. Turn off the power to the dishwasher, then turn the
power back on again.
2. Press the program button to select the desired wash
program.
3. Press the start button.
NOTE: Water remaining inside the dishwasher from
the previous program will automatically be drained
when the dishwasher starts. You should check the
status of the automatic detergent dispenser to make
sure the detergent was not expelled during the previ
ous program. Replenish detergent if necessary.
At the end of the wash
5. Press the Start/Reset button to start the program.
6. After the wash cycle is complete, switch off the
machine. Always exercise extreme caution when
opening the door and removing dishes immediately
after a dishwasher program has just ended (the dish-
es will be extremely hot and can burn your hands).
Leaving the door slightly ajar will allow hot vapors to
escape, expediting the cooling down process.
Dbhwasher Accessories
7
l
2
3
#
5 9
d
The end of a wash program is identified as follows;
• The time display will "flash" for 8 seconds.
• An audible alarm will sound (during the same 8 second
period).
NOTE: When the dishwasher program stops at the end of a
"delayed start" program (only), the time display will flash,
but there is no audible signal.
11
rm rm
0 o
o
1. Upper Rack
2. Spray Arms 4. Water Softener
3. Lower Rack 5. Main Filter
3a.Third Tier Spray 6. Detergent Dispenser
Nozzle
7. Cup Shelf
8. Silverware Basket
9. Coarse Filter
10.Rinse Agent
Dispenser
11. Inlet Valve
12.Junction Box