Silverwarebasket; Filtering System; Caring For The Dishwasher - Danby Silhouette DDW2405W Instruction Manual

SILVERWAREBASKET
Silverware should be placed in the silverware basketL Always exercise caution with sharp or pointed objects when load-
ing and!or unloading utensils: Laige and long utensils Should be Placed ina
horizonta! position on the upper dish-rack_
1 Forks 5 Knife
2 Soup Spoons 6 Serving spoon
# 3 Dessert Spoons 7 Gravy ladle
4 Teaspoons 8 Serving fork
tdtttlbr,
ff
A WARNING!
Do not let any item extend through bottom.
Filtering System
For your convenience, we haye placed the drain pump and filtering system within easy reach inside the tub. There are
three components of the filtering system; the main filter, the coarse filter, and the fine filter.
1
Main filter
Food particles trapped by this filter are pulverized by a special jet on the lower
spray arm and washed down the drain.
Coarse Filter
Larger items that could clog the drain, such as pieces of bone or glass, are
trapped in the coarse filter. To remove an item caught in this filter, gently
squeeze the tabs on the top of this filter and lift it out.
3 Fine Filter
This filter holds soil and food residue in the sump area and prevents it from
being deposited on the dishes during a cycle.
Caring for the Dishwasher
To clean the control panel, use a lightly dampened cloth then dry thorOUghly.
To clean exterior, use a good appliance polish wax. Never use sharp objects; sc0udng
pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
If your dishwasher is left in an unheated place during the
winter, ask a service technician to:
1.
Cut off electrical power to the dishwasher
2. Turn off the water supply and disconnect
the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water
valve. (Use a pan to catch the water.)
4. Reconnect the water inlet pipe to the
water valve.
5. Remove the plastic sump cover in the
bottom of tub and use a sponge to
soak up water in the rubber boot.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the arm jets and bearings. To remove
the upper spray arm, unscrew the retaining nut that is holding the arm to the rack. To remove the lower spray arm, pre-
vent the arm itself from rotating while the retaining nut is unscrewed and remove the arm.
Wash the arms in warm soapy water and use a soft brush to clean the jets. Replace them after they have been rinsed
thoroughly.