Setting Surface Controls - Kenmore 790.9760 Series Use & Care Manual

Setting Surface Controls
Surface Cooking Settings
Use the chart (Figure 1) to determine the correct setting for the kind of food you are
preparing. The Simmer settings are used to simmer and keep larger quantities of foods
warm such as stews and soups. The lower Simmer settings are ideal for delicate foods
and melting chocolate or butter.
Note: The size and type of cookware used will influence the setting needed for best
cooking results.
HIGH (Hi) Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (5-8) Continue a rapid boil, fry, deep fat fry
Maintain a slow boil, thicken sauces and gravies, steam
MEDIUM (5)
vegetables
MEDIUM LOW (2 - 4) Keep foods cooking, poach, stew
LOW (Lo - 2) Keep warm, melt, simmer Figure ]
_The suggested settings are based on cooking in medium thickness aluminum pans
with lids. Settings may vary when using other types of pans.
Operating Single Radiant Surface Elements
The cooktop has single radiant surface elements at 2 locations; the right rear and
the left rear (Figure 2) element positions.
To Operate the Single Surface Elements:
]. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the desired
setting (Figure 3). Turn the knob to adjust the setting if desired. Start most
cooking operations on a higher setting and then turn to a lower setting to finish
cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge
of the cookware indicates the cookware is too small for the surface heating
area.
3. When cooking has completed, turn the surface control knob to OFF before
removing the cookware.
Note: The Element On Indicator light will turn on when the surface element is
turned on and will turn off: when the surface element is turned off:. The Hot Surface
indicator light will turn on when the glass cooktop is hot and will continue to glow
until the glass cooktop has cooled down to a moderate level. The light may remain
on even though the controls are turned OFF.
Note: See above, Figure ] for recommended control settings.
Hot Surface
Indicator Light
Radiant surface
elements may appear to have
cooled after they have been turned
off:. A hot surface indicator light will
come on and will continue to glow
until the glass cooktop has cooled
down to a moderate level. The glass
surface may stiH be hot and burns
may occur if the glass surface is
touched before the indicator light
has turned off:.
__'_ Do not place plasffc
items such as saff and pepper
shakers, spoon holders or plastic
wrappings on top of the range
when ff is in use. These items could
melt or ignite. Potholders, towels
or wooden spoons could catch fire
if placed too close to the surface
elements.
Figure 2
Figure 3
Element On
Indicator Light