Side Burner - Kenmore 146.23681310 Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

Side Burner
Loosen side burner in side shelf by unscrewing and removing the two front screws holding the burner in
place. See A. Note: Do not loosen electrode screw.
Side burner black ground line has two wires running into one connector tip. Runlonger wire through vent
hole above ignition module in side panel into right cabinet. Securely attach tip of long wire to connector
pin on regulator valve assembly. See B.
Remove the 2 pre-installed screws from the valve control stem and set them aside. See C.
Insert valve control stem through hole in fascia. Attach bezel to fascia and valve face with previously
removed 2 screws. Attach bezel with black mark facing up. See D.
Place side burner tube over the valve orifice, making sure the orifice is inside the burner tube. Reattach
side burner to side shelf with the 2 previously removed screws. See E.
Run orange side burner ignition wire shown E from burner through side panel vent hole and into main
cabinet. Connect wire in later step.
Pushcontrol knob onto side burner valve control stem, and place cooking grate onto burner. See F.
A
j/
o
\
40 "146.23686310

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

CopperBlackRed

Table of Contents