Leveling The Refrigerator Door; Handle Removal; Handle Installation - Kenmore 795.5103 Series Use & Care Manual

LEVELING THE REFRIGERATOR DOOR
Place level on top of the refrigerator as shown below.
If your refrigerator is not level, insert a fiat blade screwdriver
into the grooves of the leveling legs (shown in picture below).
Rotate legs clockwise to raise or counterclockwise to lower the
front of the refrigerator.
Left leveling leg Right leveling leg
Raise the front of the refrigerator enough so the doors close
freely when opened halfway. The refrigerator should slope 1/4"
(6.35 rnm) to 1/2" (12. 7 ram) from front to back.
Then level the refrigerator from side to side.
HANDLE REMOVAL
You may have to remove the door handles to move the
refrigerator through a narrow opening. See instructions below.
NOTE: To avoid damaging door surfaces when moving
the refrigerator through narrow openings, it is ALWAYS
recommended to remove the doors as instructed in the next
two pages.
° Loosen the set screws with a _32" (2.38 mm) Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need to be tightened
or moved, use a 1/4" (6.35 mm) Allen wrench.
Mounting
fasteners
rew
_/ Allen wrench
HANDLE INSTALLATION
Place the handle on the door by adiusting handle footprints
to fit mounting fastners and tighten the set screws with a _32"
(2.38 ram) Allen wrench .
NOTE: If the handle mounting fastners need to be tightened
or removed use a 1/4" (6.35 mm) Allen wrench.
9