Performance Data Sheet - Kenmore 795.5103 Series Use & Care Manual

Filter Performance Data Sheet
Model Number ADQ72910902
Use with replacement cartridge ADQ72910902
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration Jess than
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42.
j System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine, Taste and
Odor and Nominal Particulate Class III.
Min.
Avg. Product Average % Required Max. Efifluent
Average Influent challenge Water Reduction mg/L
Contaminant Reduction Infiuent concentration Concentration Reduction
Particulate Class Ill
At least 10 000
Particle size:>0.gumtO 48000 P _ _ / _-art:cJes/mJ 7.5 99.9 _>85% 26
<1
]_m
Chlorine taste and odor 2.0 mg/L 2.0 mg/L J+ 10% mg/L 97.4 _>50% 0.06 mg/L
° To a capacity of 500 gallons (1892 L).
° Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Water pressure 20 - 125 psi (138 - 862 kPa)
Water temperature 34°F - IO0°F (1°C - 37.8°C)
Service flow 0.5 gpm (1.9 Ipm)
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologicaJly unsafe or of unknown quality.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance with
manufacturer's recommended procedures and guidelines.
To reduce the risk of property damage due to water
leakage:
° Read and follow Use instructions before installation and
use of this system.
° Install on COLD water lines only.
° Company with all state and local plumbing codes. Never
install or operate where inlet water pressure may exceed
125 psi (862 kPa).
° Protect filter from freezing. Remove filter in temperatures
below 34°F (1°C).
° Replace cartridge at specified service interval. Cartridge
MUST be replaced at least every 6 months.
* After replacing the water filter cartridge, dispense 2.5
gallons (9.46 liters) of water to purge the system,
depressing and releasing the dispenser pad in cycles
of 30 seconds ON and 60 seconds OFF. Discard the
purged water.
To purchase a replacement filter0 visit your local Sears store
or call 1-800-4-MY-HOME ®.
Visit us on the web at www.sears.com
Product distributed in the United States by Sears Brands
Management Corporation, Haft:man Estates, IL 60179.
22