Water Filter - Kenmore 795.5103 Series Use & Care Manual

WATER FILTER
° Filter Reset: When the Filter Reset icon turns on, you
........
====_TE_
have to change the water filter. Press the Filter Reset
button for 3 seconds to turn the icon off.
Before removing or insfalllng the water filler
1. IMPORTANT: Turn off household water supply.
2.Take out the top shelf and move it to the lowest level.
Removing the wafer filter
Remove old filter by turning it counterclockwise a quarter
turn and pulling it down. The subsflfufe cap musf be refalned
for fhe future. If fhe filler is removed and nor replaced, if
is necessary fo relnsfall fhe subsflfufe cap fo prevent wafer
leaks from the filter housing.
°,00,0°
2. Push the water filter up into the filter receptacle and rotate
it clockwise to loci< it into place.
Once
installed correctly,
the loci< symbol i_ should be facing you and you should not
be able to rotate the filter clockwise anymore.
NOTE: After installation, if you notice that the lock symbol i_
is not facing you or you can continue to rotate the filter
clockwise; remove the filter and repeat installation to prevent
water leaks.
After installing fhe wafer filler
1. Replace the shelf to the initial position.
2.After installing filter, turn on household water supply.
3.Dispense 2.5 gallons (9.46 liters) of water to purge the
system, depressing and releasing the dispenser pad in
cycles of 30 seconds ON and 60 seconds OFF. Open the
refrigerator door and check the shelf area for water leaks.
To purchase replacement water filters, call
1-800-4-MY-HOME ®.
Insfalllng the wafer filter
1. Remove the red cap from the fiJten
Hold the filter with the unlock symbol E:_ facing towards
you as shown in the figure below. Insert the filter into
the filter receptacle on the right side of the refrigerator
compartment.
21