Kenmore 119.16161210 Use & Care Manual page 8

Rotisserie Burner Igniter Lighting
• Do not lean over grill while lighting.
1. Open lld during lighting. Turn on gas at LP cylinder.
2. Push and turn the rotisserie burner control knob to
S Hi and hold in. You will hear a clicking sound as the
burner is being ignited. Ignition should occur within 5
seconds, but continue to hold the knob in for 10 to 30
seconds to activate the heat sensor and maintain
ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does NOT occur in 5 seconds, turn the
burner control OFF. Wait 5 minutes for gas to clear
away, and repeat the lighting procedure.
Searing Side Burner Igniter Lighting
• Do not lean over grill while lighting.
1. Open the side burner lid during lighting. Turn on the
gas at LP cylinder.
2. Push and turn the side burner knob to SHi and hold
in. You will hear a clicking sound as the burner is
being ignited. Ignition should occur within 5 seconds,
but continue to hold the knob in for a full 10 seconds
to maintain ignition.
3. Once burner has ignited, turn knob to desired heat
setting.
4. If ignition does NOT occur in 5 seconds, turn the
burner control knob to OFF. Wait 5 minutes for gas
to clear away, and repeat the lighting procedure.
Side Burner
Match Lighting the Main Burners
1. Place match into match holder (hanging on inside
cabinet door).
2. Strike the match and position lit match through the
grates and hold next to the burner.
3. Push in and turn burner control knob to SHi. Continue
to press in on the control knob until the burner ignites
or up to 5 seconds.
4. If ignition does NOT occur in 5 seconds, turn the
burner control knob OFF, wait 5 minutes for gas to
clear away, and repeat the lighting procedure.
5. When lit, turn knob to desired heat setting.
Match Lighting the Rotisserie Burner
1. Place match into match holder. Strike the match and
position it close to the front of the rotisserie burner.
2. Push in and turn rotisserie burner control knob to SHi.
Continue to press in on the control knob until the
burner ignites. Ignition should occur within 5 seconds,
but continue to hold the knob in for 10 to 30 seconds
to activate the heat sensor and maintain ignition.
3. If ignition does NOT occur in 5 seconds, turn the
burner control knob OFF_ wait 5 minutes for gas to
clear away, and repeat the lighting procedure.
4. When lit, turn knob to desired heat setting.
Turn controls and gas source or tank OFF when
not in use.
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat
the lighting procedure. If the burner does not
ignite with the valve open, gas will continue to
flow out of the burner and could accidentlv
ignite with risk of injury.
Match-Lighting
• Do not lean over grill while lighting.
• Open lld. Turn on gas at LP cylinder slowly.
• Light burners one at a time.
Match Lighting the Searing Side Burner
1. Place match into match holder. Strike the match and
position it close to the center of the side burner.
2. Push in and turn side burner control knob to SHi.
Continue to press in on the control knob until the
burner ignites or up to 5 seconds.
3. If ignition does NOT occur in 5 seconds, turn the
burner control knob OFF, wait 5 minutes for gas to
clear away, and repeat the lighting procedure.
4. When lit, turn knob to desired heat setting.
Match Holder
I Side Burner I