Advertisement
Available languages
Available languages
Light Operation
instructions
•
Make
sure light switch on the control
panel is in the
OFF position.
•
Connect
light plug to an extension
cord and plug the
extension
cord plug into a GFI outlet.
•
Turn the light switch on the control
panel to ON.
•
Keep any electrical
supply cord away from
any heated surface.
•
Use the shortest length extension cord
required. Do nat connect 2 or more extension
cords together.
Halogen
Bulb Specification
•
Wattage:
10W per bulb
•
Voltage:
12V
Bulb Replacement
• Make
sure light switch on the control
panel is in the
OFF position
and electrical
plug is disconnected from
its power source (outlet).
1.) Squeeze tabs on plug
together
and pull plug
out.
2.) Loosen top screws on
each side of plug.
Replace bulb and
reverse procedure
to
reinstall.
Lens Replacement
• Make
sure light switch on the control
panel is in the
OFF position
and electrical
plug is disconnected
from
its power source (outlet).
1.) Remove 2 Phillips
Head Screws securing
light assembly inside the
firebox.
2.) Grasp plug and lift
light assembly
up off
firebox
back wall.
3.) Replace
lens and
reverse procedure
to
reinstall.
Lens Cleaning
AMake
sure light switch on the control
panel is in the
OFF position
and electrical
plug is disconnected
from
its power source (outlet).
1. Ensure lens is cool.
2. Use a damp towel and warm
water to clean the
surface of the lens.
3. Allow
the lens to dry before reconnecting
the light plug
to the power supply and use.
•
Since 1971 the National
Electric Code (NEC)
has required Ground Fault Interrupter
devices on all outdoor circuits. If your
residence was built before 1971, check with
a qualified electrician
to determine if a
Ground Fault Interrupter protector exists.
•
Do nat use this appliance
if the circuit does
not have GFI protection.
•
Do nat plug this appliance into an indoor
circuit.
12
1.
To protect against electric shock, do nat
immerse cord or plugs in water or other
liquid.
2.
Unplug from the outlet when nat in use and
before cleaning.
3.
Do nat operate grill with a damaged
cord,
plug or after the appliance
malfunctions or
has been damaged
in any manner.
4.
Use only a Ground Fault Interrupter (GFI)
protected circuit with this outdoor cooking
gas appliance.
5.
Never remove the grounding plug or use
with a 2-prong adapter.
6.
Use only an extension cord with a 3 prong
grounding plug, rated far the power of the
equipment, and approved
far outdoor use
with a W-A marking.
Advertisement
