Getting Started; Battery Installation - VTech Innotab 2 Blue User Manual

Wrist Strap Fastener
Battery Door Lock Sliding
Switch
SD Card Slot
Battery Compartment
Stand

Battery Installation

• Make sure the tablet is turned off.
• Locate the battery door lock sliding switch on the
back of the tablet. Slide the switch to open the
battery door, then remove the door.
• Insert 4 "AA" batteries as shown in image 2.
• Make sure to replace the battery cover.
Battery Notice
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being
charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision
(if removable).
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc),
or rechargeable (Ni-MH).
• Only batteries of the same or equivalent type as recommended
are to be used.
If you wish, attach a wrist strap here.
Wrist strap not included.)
Slide this switch to open the battery door.
Always replace the InnoTab
after changing batteries.
Insert an SD memory card (not included).
(NOTE: InnoTab
®
SDHC memory cards up to 32GB.)
Insert 4 "AA" batteries (not included). For
battery installation instructions, please see
the next section.
Pull out this stand to prop up InnoTab
use it as a digital photo frame.
2 battery door
®
2 is compatible with SD and
1
2
(NOTE:
2 and
®
4