Ventilation Lever - Hotpoint HP21WC-Cooling Only Operating Instructions Manual

Remote control panel
Note:
If wireless remote controller is lost, open the surface panel and operate manually.
POWER BUTTON
1
Operation starts when pressing this button, and stops
when pressing this button again.
SWING BUTTON
2
Activate the automatic air swing function.
FAN SPEED BUTTON
3
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
TEMP/TIMER BUTTON
4
Press the keypad to increase the set (operating)
temperature of the unit.and Press the
decrease the set (operating) temperature of the unit.
The temperature seting range is from 16~30¡æ
Press the keypad also to increase the selected time
in 1 hour increments,and Press the
decrease the selected time in 1 hour decrements,The
time seting range is from 0~24 hours.

VENTILATION LEVER

Ventilation Lever
keypad to
keypad to
When the slider at the:
CLOSE VENT OPEN
-"OPEN" position,the ventilation door
opens to allow air,smoke or odors to
be expelled from the room.
13
5 SIGNAL RECEIVER
MODE BUTTON
6
Select the operation mode, AUTO, HEAT, COOL, FAN,
DRY (for reverse cycle model) or AUTO,COOL,FAN, DRY
(for cooling only model).
FILTER BUTTON
7
This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling. The LED (light) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press the
"Check Filter" button and the light will go off. Before the
LED(light) illuminate, press the "Check filter" button until
after 3 seconds, the accumulated time of. Operation will be
canceled.
When the slider at the:
CLOSE VENT OPEN
-"CLOSE" position,the ventilation door
is closed and the air will be circulated
inside the room and conditioned.