Honeywell ADEMCO VISTA-10P User Manual page 42

Fire Alarm System (Continued)
THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
Manually 1. Should you become aware of a fire emergency before your smoke or
Initiating
a Fire Alarm
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify
4.
Using the A key or key pair may have been assigned for manually initiating a FIRE
Panic Key(s) alarm. See the Panic Keys section for key assignments.
For convenience, indicate the key or key pair assigned for fire below.
Assigned for
FIRE In divi d ua l K e y s
Emergency
OR Key Pai r s
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
Carbon If installed, carbon monoxide detectors provide continuous protection.
If a high level of carbon monoxide is detected, an interrupted pulsed
Monoxide
alarm sound occurs at the keypads and the detector(s). Immediately
Alarms
move to a spot where fresh air is available, preferably outdoors. From
a safe area, call your security service provider for further instructions.
To silence the keypad sounding, press the OFF key. To silence the
detector, see its instructions.
– 42 –
heat detectors sense the problem, go to your nearest keypad and
manually initiate an alarm by pressing the panic key assigned for
FIRE emergency for 2 seconds. If a key pair has been assigned for
fire, press both keys at the same time. See the Using the Panic Keys
section below for further details.
your local Fire Department immediately.
If no flames or smoke are apparent, investigate the cause of the
alarm. The zone number(s) of the zone(s) in an alarm condition will
be displayed at the keypad.
A B C
Press
1
and
O F F
∗
and
R E A D Y
3
and
S T A Y
F I R E 9 5
ALPHA DISPLAY KEYPAD
the individual key assigned for fire
∗
( z o n e 9 5 )
R E A D Y
Press
#
( z o n e 9 9 )
for fire
#
( z o n e 9 6 )
95 95 95 95
ALARM
FIRE
FIXED-WORD KEYPAD
for 2 seconds.
the key pair assigned
at the same time.
AC