Honeywell ADEMCO VISTA-10P User Manual page 33

5. For event number "02," enter the access group
number. Otherwise, this prompt is skipped.
Press [∗] to continue to the "Start" prompt below.
6. Enter the event's start time and days of week.
Hour = 00-12; minute = 00-59
AM = 0; PM = 1
Days = Position the cursor under the desired days
using the [∗] key to move forward, then press "1"
to select the day.
Press [∗] to continue.
7. If applicable, enter the event's stop time and days
of week (applies only to event numbers 01, 02, and
03).
Refer to step 7 for available entries.
Press [∗] to continue.
8. Enter the desired repeat option.
0 = no repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly (every other week)
3 = repeat schedule every third week
4 = repeat schedule every fourth week
e.g., To make a schedule that happens everyday
you would select all days with a repeat count of 1.
To make a schedule that runs for one week then
stops, select everyday with a repeat count of 0.
9. For event number 01 (output on/off), select the
desired randomize option. 0 = no; 1 = yes
If selected, the schedule times will vary within 60
minutes of the "hour" time. For example, if a
schedule is set to start at 6:15pm, it will do so the
first time 6:15pm arrives, but on subsequent days
it will start anytime between 6:00 and 6:59 p.m.
Press [∗] to return to first prompt, then enter 00
to quit.
Scheduling (continued) Scheduling (continued)
Scheduling (continued) Scheduling (continued)
GROUP NUMBER
X
START SMTWTFS
HH:MMAM 1000000
STOP SMTWTFS
HH:MMAM 1000000
REPEAT OPTION
0-4 X
RANDOMIZE
0=NO 1=YES X
– 33 –