Entry/Exit Delays; Exit Delay; Entry Delay - Honeywell ADEMCO VISTA-10P User Manual

Entry/Exit Delays

Entry/Exit Delays
Entry/Exit Delays Entry/Exit Delays
Your system has preset time delays, known as exit delay and entry delay.

Exit Delay

Exit Delay Exit Delay Exit Delay
Exit delay gives you time to leave through the designated exit door(s) without
setting off an alarm. Exit delay begins immediately after arming your system in any
arming mode and Alpha Display keypads display the message "You May Exit Now."
When "You may exit now" disappears, the system is fully armed. If programmed, a
slow beeping will sound during the exit delay period until the last 10 seconds, which
then changes to fast beeping (alerting you to the end of exit delay). If you cannot
leave by this time, you should stop, disarm the system, and start over to avoid a false
alarm.
Exit Delay Restart/Reset. If you wish to open the entry/exit door to let someone in
after arming STAY, you can re-start the exit delay at any time – simply press the
[✱] key, then let that person in (the perimeter zones remain armed). The system
automatically re-arms the entry/exit door when exit delay expires, which avoids
having to disarm the system and then re-arm it again.
In addition, when the system is armed AWAY, reopening and closing the entry/exit
door before exit delay time expires (e.g., reentering to get a forgotten item) will reset
the exit delay time once.

Entry Delay

Entry Delay
Entry Delay Entry Delay
Entry Delays give you time to disarm the system when you re-enter through the
designated entrance door. There are two entry delays (if programmed). The first is for
your primary entrance and the second can be used for a secondary entrance, where a
longer delay is required to walk to the keypad to disarm the system.
You must disarm the system before the entry delay period ends, or an alarm will
occur. The keypad beeps during the entry delay period, reminding you to disarm the
system. The beeps stop when a code is entered, but will restart after about 15 seconds
if an invalid code is entered.
You can also arm the system with no entry delay at all by using the INSTANT or
MAXIMUM arming mode. This mode provides greater security while on the
premises or while away for extended periods of time.
See your installer for your delay times.
Exit Delay:
– 12 –
seconds Entry Delay 1:
Entry Delay 2:
seconds
seconds