Disarming And Silencing Alarms; Using The 1 Off Key; Memory Of Alarm - Honeywell VISTA-128FBP User Manual

Using the 1 OFF Key

The OFF key is used to disarm the system and to silence alarm and trouble
sounds. See Summary of Audible Notification section for information that
will help you to distinguish between FIRE and BURGLARY alarm sounds.
IMPORTANT: If you return and the main burglary sounder is on, DO NOT enter
the premises, but call the police from a nearby safe location. If you return after an
alarm has occurred and the main sounder has shut itself off, the keypad will beep
rapidly upon entering, indicating that an alarm has occurred during your absence.
LEAVE the premises IMMEDIATELY and CONTACT THE POLICE from a
nearby safe location.
To disarm the system and silence burglary or fire alarms:
1. Enter your security code and press
2. The Ready message will be displayed (if no alarms have occurred while
armed) and the keypad will beep once to confirm that the system is
disarmed.

Memory of Alarm

The keypad displays the zone number and type of alarm for any zone that
has an alarm condition. These messages will remain displayed until cleared
by a user. If an alarm has occurred, note the zone number displayed on the
keypad and repeat step 1 above to clear the "Memory of Alarm" and restore
the Ready message display. If the Ready message will not display, go to the
displayed zone and remedy the fault (close windows, etc.). If the fault cannot
be remedied, notify the alarm agency.
If the system was armed when the alarm occurred, repeat step 1 twice: once
to disarm the system, a second time to clear the display.

Disarming and Silencing Alarms

DISARMED
READY TO ARM
OFF
.
1
– 39 –