Honeywell HSVR-04 User Manual page 57

Boot up the DVR, and input the user name and password.
In the main menu, select SettingPan/Tilt/Zoom. The interface is shown
as in Figure 4-27. Here you can set the following items:
Channel: Select the channel connected with the speed dome video

port.
Protocol: Select the corresponding PTZ protocol (such as PELCOD).

Address: Identical to the device address set in the speed dome.

Default address is 1.
Baud rate: Select corresponding baud rate. 2400 for Pelco-D

protocol.
Data bits: Select corresponding data bits. Default value is 8.

Stop bits: Select corresponding stop bits. Default value is 1.

Parity: There are three options: Odd/Even/None. The default value

is None.
Figure 4-27 PTZ Setup Menu
After completing all the settings click Save.
In the single window display (View 1) mode, right-click to open the interface
shown in Figure 4-28
controller will cause a menu to appear with only Pan/Tilt/Zoom and Color
Setting options). .
(by clicking Fn in the front panel or in the remote
Honeywell
49